| Vin (Min) (V) | 2 |
| Vin (Max) (V) | 5.5 |
| Vout (Min) (V) | 0.9 |
| Vout (Max) (V) | 5 |
| Iout (Max) (A) | 0.3 |
| Iq (Typ) (uA) | 50 |
| Switching frequency (Min) (kHz) | 500 |
| Switching frequency (Max) (kHz) | 1000 |
| Features | Adjustable Current Limit, Enable, Frequency Synchronization, Light Load Efficiency, Power Good, Synchronous Rectification |
| Rating | High Temp |
| Regulated outputs (#) | 1 |
| Control mode | Current Mode |
| Duty cycle (Max) (%) | 100 |
- High-Efficiency Synchronous Step-Down Converter
With Greater Than 95% Efficiency - 2 V to 5.5 V Operating Input Voltage Range
- Adjustable Output Voltage Range From 0.8 V to VI
- Synchronizable to External Clock Signal up to 1 MHz
- Up to 300 mA Output Current
- Pin-Programmable Current Limit
- High Efficiency Over a Wide Load Current Range in
Power Save Mode - 100% Maximum Duty Cycle for Lowest Dropout
- Low-Noise Operation Antiringing Switch and
PFM/PWM Operation Mode - Internal Softstart
- 50-μA Quiescent Current (TYP)
- Evaluation Module Available for Commercial
Temperature Range - APPLICATIONS
- Down-Hole Drilling
- High Temperature Environments
- SUPPORTS EXTREME TEMPERATURE APPLICATIONS
- Controlled Baseline
- One Assembly/Test Site
- One Fabrication Site
- Available in Extreme (–55°C/210°C)
Temperature Range(1) - Extended Product Life Cycle
- Extended Product-Change Notification
- Product Traceability
- Texas Instruments high temperature products utilize
highly optimized silicon (die) solutions with design
and process enhancements to maximize performance over
extended temperatures.
(1) Custom temperature ranges available.
The TPS62000 device is a low-noise synchronous step-down dc-dc converter that is ideally suited for systems powered from a 1-cell Li-ion battery or from a 2- to 3-cell NiCd, NiMH, or alkaline battery. The TPS62000 operates typically down to an input voltage of 1.8 V, with a specified minimum input voltage of 2 V.
The TPS62000 is a synchronous current-mode PWM converter with integrated N- and P-channel power MOSFET switches. Synchronous rectification is used to increase efficiency and to reduce external component count. To achieve the highest efficiency over a wide load current range, the converter enters a power-saving pulse-frequency modulation (PFM) mode at light load currents. Operating frequency is typically 750 kHz, allowing the use of small inductor and capacitor values. The device can be synchronized to an external clock signal in the range of 500 kHz to 1 MHz. For low-noise operation, the converter can be operated in the PWM mode and the internal antiringing switch reduces noise and EMI. In the shutdown mode, the current consumption is reduced to less than 1 μA. The TPS62000-HT is available in the 10-pin (HKK). The device operates a free-air temperature range of ?55°C to 210°C.
